收藏本站
SAW Components
SAW filter
B3743
433.92 MHz
Data sheet
ESD protection of SAW filters
SAW filters are E lectro S tatic D ischarge sensitive devices. To reduce the probability of damages
caused by ESD, special matching topologies have to be applied.
In general, “ESD matching” has to be ensured at that filter port, where electrostatic discharge is
expected.
Electrostatic discharges predominantly appear at the antenna input of RF receivers. Therefore
only the input matching of the SAW filter has to be designed to short circuit or to block the ESD
pulse.
Below two figures show recommended “ESD matching” topologies.
Depending on the input impedance of the SAW filter and the source impedance, the needed
component values have to be determined from case to case.
Ls3
Ls3
Lp2
to output
matching
Dp1
Lp2
to output
matching
Fig. 1 MLC varistor plus ESD matching
Fig. 2 Suppressor diode plus ESD matching
In cases where minor ESD occur, following simplified “ESD matching” topologies can be used
alternatively.
Ls2
Cs1
Lp1
Fig. 3 shunt L – series L matching
to output
matching
Lp2
Fig. 4 series C – shunt L matching
to output
matching
Effectiveness of the applied ESD protection has to be checked according to relevant industry
standards or customer specific requirements.
For further information, please refer to EPCOS Application report:
“ ESD protection for SAW filters ”. This report can be found under www.epcos.com/rke . Click on
“data sheets” and then “Applications” under category “Further information”.
Please read cautions and warnings and
important notes at the end of this document.
6
December 19, 2012
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
B39431B3748H110 FILTER SAW 434.42MHZ SMD
B39431B3760Z810 FILTER SAW 433.92MHZ REMOTE SMD
B39431B3770Z810 FILTER SAW 426.08MHZ SMD
B39431B3774Z810 FILTER SAW 433.92MHZ SMD
B39431B3780Z810 FILTER SAW 433.92MHZ SMD
B39431B3782Z810 FILTER SAW 433.92MHZ SMD
B39431B3790Z810 FILTER SAW 433.92MHZ SMD
B39431B3932H110 FILTER SAW 434.17MHZ SMD
相关代理商/技术参数
B39431B3745H110 功能描述:信号调节 434.2 MHz RoHS:否 制造商:EPCOS 产品:Duplexers 频率:782 MHz, 751 MHz 频率范围: 电压额定值: 带宽: 阻抗:50 Ohms 端接类型:SMD/SMT 封装 / 箱体:2.5 mm x 2 mm 工作温度范围:- 30 C to + 85 C 封装:Reel
B39431B3748H110 功能描述:谐振器 RoHS:否 制造商:Murata 频率:30 MHz 容差:25 PPM 系列:XRCGB 端接类型:SMD/SMT 工作温度范围:- 10 C to + 70 C 尺寸:1.6 mm W x 2 mm L x 0.65 mm H 封装:Reel
B39431B3750U310 功能描述:信号调节 B3750 FRONTEND FILTER RoHS:否 制造商:EPCOS 产品:Duplexers 频率:782 MHz, 751 MHz 频率范围: 电压额定值: 带宽: 阻抗:50 Ohms 端接类型:SMD/SMT 封装 / 箱体:2.5 mm x 2 mm 工作温度范围:- 30 C to + 85 C 封装:Reel
B39431-B3750-U310 制造商:EPCOS 制造商全称:EPCOS 功能描述:Low-loss Filter
B39431B3757U310 功能描述:信号调节 B3757 FRONTEND FILTER RoHS:否 制造商:EPCOS 产品:Duplexers 频率:782 MHz, 751 MHz 频率范围: 电压额定值: 带宽: 阻抗:50 Ohms 端接类型:SMD/SMT 封装 / 箱体:2.5 mm x 2 mm 工作温度范围:- 30 C to + 85 C 封装:Reel
B39431-B3757-U310 制造商:EPCOS 制造商全称:EPCOS 功能描述:SAW Components Low-loss Filter 434,42 MHz
B39431B3760Z810 功能描述:信号调节 B3760 FRONTEND FILTER RoHS:否 制造商:EPCOS 产品:Duplexers 频率:782 MHz, 751 MHz 频率范围: 电压额定值: 带宽: 阻抗:50 Ohms 端接类型:SMD/SMT 封装 / 箱体:2.5 mm x 2 mm 工作温度范围:- 30 C to + 85 C 封装:Reel
B39431-B3760-Z810 制造商:TDK-EPC 功能描述:SAW Filter 433.92MHzFrequency 0.74MHz 50Ohm SMD 8Pin QCC8B 制造商:EPCOS 功能描述:SAW Filter 433.92MHzFrequency 0.74MHz 50Ohm SMD 8Pin QCC8B